• The Rotate buttons turn 45° a click instead of 90°, so leaning a part back is one click and 90° is two.

v1.0.4 2026-11-05

• Full coverage no longer builds a wall through the part where its underside steps: the wall becomes two, one each side of the step, so it still breaks away cleanly. Draw mode asks for two lines there.
• Auto builds about a quarter faster on some tilted parts, with the same supports.

v1.0.3 2026-11-05

• Full coverage builds live: walls appear as they're placed, a progress bar shows how far along it is, and Stop keeps what's shown.
• Full coverage builds up to twice as fast on big or busy parts, with the same supports.

v1.0.2 2026-11-03

• Anchor fins can be short, down to 5 mm: click low on a side for a doorstop that keeps a tall part on a small base from tipping, with Brace depth up to 200%. From BorisKozo's Stabilizer (#426).
• Anchor fins: a tool of its own for holding a leaning part from its up-facing back, curved or flat, without turning on Auto's sway braces. Sway braces go back to upright sides; a leaning back now takes an anchor.
• A brace placed by hand now follows a side that curves up its height, convex or concave, instead of only standing on flat spots.
• CLI preserved projects can bake negative parts for print-by-object, retaining exterior painting and part settings, with complete resume checkpoints and warnings to verify sliced materials and clearance.
• Try longitudinal walls for isolated narrow struts left unsupported by the normal placement.

v1.0.1 2026-10-30

• Support gently bent small tubes using their actual curved underside.

v1.0.0 2026-10-29

• Full coverage mode: every red overhang gets support, with a second pass for figures
• Curved, downhill and arc walls that follow an overhang to the plate
• Cleaner snap-off: tines touch the part's surface instead of biting in, and the 3MF exports supports as their own object
• Plugins for Orca, Cura, Fusion, FreeCAD, Blender, SolidWorks, Rhino and PrusaSlicer, on the same engine as the site
• Calibrate menu: test prints that tune the fins to your printer
• Several models on one plate, with Move and Arrange
• Any nozzle from 0.2 to 2.0 mm, layers up to 0.6 mm, and thicker walls
• Resin: pins that snap at the surface and feet a scraper can get under
• Interface material for toolchanger printers
• Works on phones, and in German, Dutch, Portuguese, Chinese and Arabic